TM 5-5420-228-24
HEU VALVE BANK ASSEMBLY CONTROLS REPLACEMENT (Sheet 1 of 2)
PROCEDURE INDEX
Procedures
Page
Removal
Installation
TOOLS:
Long round nose pliers
9/16 in. combination box and open end wrench
Hammer
SUPPLIES:
Lockwasher (3 required)
REFERENCE: TM-10
PRELIMINARY PROCEDURES: None
REMOVAL:
1.
Using long round nose pliers, remove two C-clips (A) and two washers (B).
2.
Using long round nose pliers, remove ten C-clips (C).
3.
Remove ten straight pins (D) and links (E).
4.
Using long round nose pliers, slowly pull out rod (F).
5.
Remove five control levers (G).
6.
Manually remove five knobs (H) by unscrewing from control levers (G).
7.
Using 9/16 inch wrench, remove three screws (J) and three lockwashers (K). Remove control bracket (L).
Go on to Sheet 2