GENERAL MAINTENANCE - Continued
Removal of Studs Broken Below Surface (Sheet 3 of 3)
10. Using hammer, drive fluted extractor (F) into
11. Manually start nut (J) counterclockwise
on extractor (F).
12. Using wrench, tighten nut (J) on extractor
(F) by turning counterclockwise.
13. Using wrench, keep turning nut (J) counter-
clockwise until stud (D) is removed from
threaded hole (G).
14. Using clean rag, wipe out threaded hole (G) and
End of Task