• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Safety Wiring Procedures (Sheet 2 of 2)
Castellated Nuts on Undrilled Stud Double-Twist Safety Wiring

Launcher Hydraulics System M48A5/M60A1 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 Page Navigation
  687    688    689    690    691  692  693    694    695    696  
img
.
TM 5-5420-228-24
GENERAL MAINTENANCE - Continued
Single Fastener Double-Twist Safety Wiring
TOOLS: Slip joint pliers
Diagonal cutting pliers
SUPPLIES: Lockwire
1.
Using diagonal cutting pliers, cut piece of lockwire about 24 inches long.
Run wire through drilled bolt head (A),
2.
keeping length of free wire ends the same.
3.
Using slip joint pliers, twist wire until wire
twist almost reaches drilled hole (B) in plate.
Run one leg of wire through drilled hole (B) in
4.
plate.
Using slip joint pliers, twist wire at least six
5.
times.
Using diagonal cutting pliers, cut wire leaving a
6.
pigtail from 1/4 to 1/2 inch long.
Bend pigtail back under to prevent it from
7.
becoming a snag.
End of Task
TA251298
C-30






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.