LOADING BAP FROM GROUND
The winch frame must be locked to the BAP prior to
loading BAP from ground. Failure to comply may result
in damage to equipment or injury to personnel.
When both levers are in the UP position, the winch
frame is locked to the BAP. Perform steps a and b if
levers are in the DOWN position.
During all transporter operations, the CBT operator
will drive and be responsible for the operation of the
LHS via the cab and remote control boxes. The
assistant will act as a ground guide, be responsible for
directing the operator using hand signals, and assist
the operator as needed.
a. Remove quick-release pin (2) from stud (3) at both sides of winch frame (1).
b. Swing lever (4) up so that end of stud (5) is through hole in lever (4), and
install quick-release pin (2) on stud (5) at both sides of winch frame (1).