TM 5-5420-278-10
0023 00
0023
UNLOADING BAY TO GROUND
CAUTION
Assistant will act as ground guide when maneuvering
CPT and during operation of the LHS. Failure to
comply may result in damage to equipment.
NOTE
During all transporter operations, the CBT operator
will drive and be responsible for the operation of the
LHS via the cab and remote control boxes. The
assistant will act as a ground guide, be responsible for
directing the operator using hand signals, and assist
the operator as needed.
a. Check hold-down lock (1) at both sides of BAP to ensure they are in AUTO
ENGAGED position; handles (2) should be in.
WARNING
The winch frame must be locked to the LHS hook arm
prior to unloading the bay to the ground. Failure to
comply may result in damage to equipment or injury to
personnel.
NOTE
When both levers are in the DOWN position, the winch
frame is locked to the LHS hook arm. Perform steps d
and e if levers are in the UP position.
b. Remove quick-release pin (7) from stud (5) at both sides of winch frame (6).
c. Swing lever (4) down so that end of stud (3) is through hole in lever (4), and
install quick-release pin (7) on stud (3) at both sides of winch frame (6).
1
2
5
4
3
7
6