FREE LAUNCH OF BAY (Contd)
The winch frame must be locked to the LHS hook arm
prior to unloading the bay to the ground. Failure to
comply may result in damage to equipment or injury to
When both levers are in the DOWN position, the winch
frame is locked to the LHS hook arm. Perform steps q
and r if levers are in the UP position.
q. Remove quick-release pin (5) from stud (3) at both sides of winch frame (4).
r. Swing lever (2) down so that end of stud (1) is through hole in lever (2), and
install quick-release pin (5) on stud (1) at both sides of winch frame (4).
ramp bay or step t if
launching interior bay.
s. Open both foldlocks (6) and travel latch (7) at rear (connecting end) of ramp bay.
t. Open both foldlocks (8) and travel latches (9) at both ends of interior bay.