MANUALLY UNLOADING BAP TO GROUND (Contd)
Winch frame must be locked to BAP prior to loading
BAP from ground. Failure to comply may result in
damage to equipment or injury to personnel.
When both levers are in the UP position, the winch
frame is locked to the BAP. Perform steps b and c if
levers are in the DOWN position.
b. Remove quick-release pin (5) from stud (7) at both sides of winch frame (6).
c. Swing lever (8) up so that end of stud (4) is through hole in lever (8), and
install quick-release pin (5) on stud (4) at both sides of winch frame (6).
Perform steps d and e if BAP winch hydraulic hoses are
connected to LHS couplings or disconnected from
d. Disconnect winch hydraulic hoses (9) and (13) from LHS couplings (10) and
(12), located on LHS hook arm (11).
e. Connect winch hydraulic hoses (13) and (9) to stowage couplings (12) and
(10), located on winch frame bracket (14).