TM 5-5420-278-24&P
0029 00
0029 00-2
FOLDLOCK REPLACEMENT (Contd)
NOTE
Removal and installation of foldlocks are performed the same way
for left and right sides. Left side is shown.
REMOVAL
1.
Remove cotter pin (8) from spring support (9) and pin (7), and remove pin (7) from spring
support (9) and mounting block (6). Discard cotter pin (8).
2.
Remove locknut (15) and spacer (14) from spring support (9). Discard locknut (15).
3.
Remove spring support (9) and pin (13) from lever (1), and remove washer (10), springs (11) and
(12), and washer (10) from spring support (9).
4.
Remove two cotter pins (2) and washers (3) from pin (5). Remove pin (5), lever (1), and mounting
block (6) from inner ponton supports (4). Discard cotter pins (2).
5.
Perform steps 1 through 4 to remove opposite foldlock.
INSTALLATION
1.
Install lever (1) and mounting block (6) on inner ponton supports (4) with pin (5), two washers (3),
and new cotter pins (2).
2.
Position washer (10), springs (11) and (12), and washer (10) on spring support (9), and position
pin (13) and spring support (9) on lever (1).
3.
Compress springs (11) and (12), and install spacer (14) and new locknut (15) on spring support (9).
4.
Connect spring support (9) to mounting block (6) with new cotter pin (8).
5.
Perform steps 1 through 4 to install opposite foldlock.
2
3
4
6
5
3
2
8
9
10
11
12
10
13
14
15
1
7
END OF WORK PACKAGE