TM 5-5420-278-24&P
0036 00
0036 00-4
CYLINDER REPLACEMENT (Contd)
INSTALLATION
1.
Install new gasket (16) and adapter (17) on cylinder housing (15).
2.
Apply sealant to male threads of adapter (7) and install adapter (7) on cylinder housing (15).
3.
Apply sealant to male threads of adapter (11) and install adapter (11) on fluid lock assembly (8).
NOTE
Assistant will help with step 4.
4.
Using lifting device, strap, and assistant, position cylinder housing (15) and cylinder end yoke (9) in
opening (10) on inner ponton (14) and install retainer pin (20) through inner ponton (14) and
cylinder end yoke (19).
5.
Install rubber stop pad (3) and access cover (2) on inner ponton (14) and retainer pin (20) with six
screws (1).
NOTE
Apply a light coat of fluid to new O-ring at installation.
6.
Install new O-ring (18) and hose assembly (4) to adapter (17) on cylinder housing (15).
7.
Install tee fitting (13) with hoses attached on adapter (11) of fluid lock assembly (8) and tighten
nut (12).
8.
Install tee fitting (5) with hoses attached on adapter (7) of cylinder housing (15) and tighten nut (6).
9.
Install pump (WP 0035 00).
10.
Fill fluid system (WP 0032 00).
11.
Install or lower yoke (WP 0030 00).
12.
If separated, connect outer and inner pontons (WP 0023 00).
13.
Bleed fluid system (WP 0038 00).
14.
Install ramp bay on transporter (TM 5-5420-278-10).