TM 5-5420-278-24&P
0073 00
0073 00-2
CLEANING (Contd)
Contact with Skysol-100 may cause skin irritation. Use chemical resistant
gloves. In case of skin contact, remove any contaminated clothing and
wash skin thoroughly with soap and water. Wash contaminated clothing
before reuse. Eye contact may cause irritation, tearing, or blurring of
vision. Use face shield or goggles when eye contact may occur. In case of
eye contact, flush eyes with large amounts of water for at least fifteen
(15) minutes or until irritation subsides. Inhalation may cause irritation
to upper respiratory passages. DO NOT have food or drink in the vicinity.
d. Castings.
(1) Clean inner and outer surfaces of castings and all areas subject to grease and fluid with
Skysol-100.
(2) Use a stiff brush to remove sludge and gum deposits.
WARNING
Compressed air source will not exceed 30 psi (207 kPa). When
cleaning with compressed air, eyeshields must be worn. Failure to
comply may result in injury to personnel.
(3) Use compressed air to blow out all tapped screw holes and to dry castings after cleaning.
e.
Fluid Passages. Particular attention must be given to all fluid passages in castings and
machined parts. Fluid passages must be clean and free of any obstructions.
(1) Clean passages with wire probes to break up any sludge or gum deposits.
(2) Wash passages by flushing with solvents.
WARNING
Compressed air source will not exceed 30 psi (207 kPa). When
cleaning with compressed air, eyeshields must be worn. Failure to
comply will result in injury to personnel.
(3) Dry passages with compressed air.
f.
Seals and Flexible Hoses.
CAUTION
Do not allow Skysol-100 to come in contact with seals or flexible
hoses. Failure to comply will result in damage to parts.
Clean with soap and water.
g. Bearings.
(1) Bearings require special cleaning. After removing surface grease and gum deposits, wipe
bearings dry; do not use compressed air. After cleaning, coat bearings with grease, wrap,
and hold for inspection.
(2) Refer to TM 9-214 for more information on care of bearings.
h. Machine Tooled Parts. Clean with Skysol-100 and dry with compressed air.
i.
Machined Surfaces. Clean with Skysol-100 and dry with lint-free cloth.