TM-5-5420-279-10
4.7.2.23
Install the final locking pin and its R clip to engage the launch beam final stop.
NOTE
It may be necessary to carry out steps 4.7.2.6 and 4.7.2.7 to install the locking pins.
Lowering the Far Bank Support
WARNING
HYDRAULIC EQUIPMENT. OPERATION OF EQUIPMENT POWERED BY HYDRAULIC
PRESSURE IS HAZARDOUS. KEEP CLEAR OF MOVING PARTS.
HYDRAULIC PRESSURE. EXPOSURE TO HYDRAULIC FLUID UNDER PRESSURE IS
HAZARDOUS. IN THE EVENT OF A HOSE OR COMPONENT FAILURE, REMOVE ALL
FLUID CONTAMINATION FROM THE SKIN AND EYES WITH CLEAN WATER AND SEEK
MEDICAL ASSISTANCE.
4.7.3.1
On the chest pack, move the joystick to the right. Make sure the POWER and FAR
BANK SEAT captions on
the chest pack display illuminate.
4.7.3.2
On the chest pack pull the joystick rearward to extend the articulator cylinders and
thus lower the far bank support to the ground.
4.7.3.3
On lowering the far bank support to the ground, make sure the far bank support tell-
tail indicator flags deploy.
4.7.3.4
If the indicator flags do not deploy, raise and lower the far bank support again.
FUNCTION
SELECT
TILT
ROLLER
CARRIAGE
STOW
EMPTY
HIGH
BANK
BEAM
FARBANK
A FRAME
MODE
BEAM
STOW
=LEVEK
L
TOP
BRIDGE
DRIVE
SEAT
RAISE
SELECT
ANGLE
ARTIC
BAN
WINCH
LIFT
LOW
EMERGENCY STOP
POWER
BANK
ROLLER
BRIGHT
OFF
FAULT
BRAKE
OFF
ON
DIM
OFF
ROLLER BRAKE
PUSHTO STOP -TWISTTO RESET
686A356c
Far Bank Seat Caption