Bridge stop emergency in down position
Bridge stop emergency in raised position
FALL HAZARD. PERSONNEL ON TOP OF THE BRIDGE MUST WEAR THE SAFETY
HARNESS. FAILURE TO HEED THIS INSTRUCTION COULD LEAD TO SEVERE INJURY.
Position a person wearing a safety harness on top of the module ensure harness
lanyard is securely connected to A-frame top cross member.
Slings should not be pulled should they become snagged, but lifted off the carriage
shootbolts. Damage to equipment could result if this instruction is not followed.
Lift the far bank carriage lifting slings from their stowed position over the carriage
Remove the R clip from the sling retractable pin and retract the pin.
Route the carriage slings through the end beam bridge lifting points and re-connect
the sling to the carriage. Ensure that the sling straps do not cross.
Make sure the sling retractable pin is fully located and secured with the R clip.
Do not detach the crane from the ramp module until the far bank carriage has been
attached and secured.