TM-5-5420-279-10
5.4.2.32
Connect the crane hook to the end beam slings and steadying rope lines to the
home bank end beam positioned on the slide frame.
5.4.2.33
Place two bridging timbers on the ground next to flatrack T1 to support the end
beam to allow the slings to be removed.
WARNING
CRUSH HAZARD. DEATH OR PERSONAL INJURY CAN RESULT IN THE EVENT OF A
SUSPENDED LOAD FALLING FROM THE CRANE. DO NOT STAND CLOSE TO LOADS
SUSPENDED FROM THE CRANE.
5.4.2.34
Operate the lift and traverse controls on the crane. Use the tag lines and guide the
home bank end beam from the launch vehicle into position on the bridging timbers.
5.4.2.35
Disconnect the crane hook from the home bank end beam slings.
5.4.2.36
Operate the crane controls on the crane and position the crane hook above the
module lifting beam.
5.4.2.37
Connect the single leg sling to the module lifting beam.
5.4.2.38
Remove the end beam adapters and the removable rollers and place on the ground
at the side of the launcher out of the way of personnel. Ensure end beam adapters
are stowed and clipped.
5-19