• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
PALLET REAR WHEEL ASSEMBLY REPLACEMENT
Schematic Drawing - TM-5-5420-280-23-P0317

TM-5-5420-280-23-P Rapidly Emplaced Bridge (REB) NSN: 5420-01-481-3959 Manual
Page Navigation
  267    268    269    270    271  272  273    274    275    276    277  
TM 5-5420-280-23&P
0035 00
PALLET REAR WHEEL ASSEMBLY REPLACEMENT (Contd)
REMOVAL
NOTE
Removal and installation of right and left pallet rear wheel
assemblies are performed the same way. Left side is shown.
1.
Support wheel spindle mounting bracket (5), and remove four nuts (6) from cylinder rod ends (2)
and wheel spindle mounting bracket (5).
2.
Slide wheel spindle mounting bracket (5) out of slide bracket (1).
3.
If damaged, remove twenty-four screws (4) and twelve guide plates (3) from wheel spindle mounting
bracket (5).
INSTALLATION
NOTE
Apply a light coat of grease to guide plates and slide bracket at
installation.
1.
If removed, install twelve guide plates (3) on wheel spindle mounting bracket (5) with twenty-four
screws (4).
2.
Slide wheel spindle mounting bracket (5) up in slide bracket (1) so cylinder rod ends (2) extend
through bracket (5), then insert retaining pin (10) in bottom hole to secure bracket (5).
NOTE
Ensure that all mounting hardware is tightened to metric
standards unless otherwise noted. Refer to metric torque limits in
WP 0118 00.
3.
Install four nuts (6) on cylinder rod ends (2) and wheel spindle mounting brackets (5).
4.
Install pallet wheel hub. Refer to WP 0037 00.
5.
Raise rear wheels. Refer to TM 5-5420-280-10.
6.
Lift pallet supporting cylinders to stowed position. Refer to TM 5-5420-280-10.
0035 00-2






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.