• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALLATION OF MOORING BITTS AND QUICK DISCONNECTS (cont)
INSTALL MOORING BITTS (cont) - TM-55-1945-205-10-2_126

TM-55-1945-205-10-2 Water Purification Barges NSN (1930-01-234-2165) Volume 9-3 Electric Power System Manual
Page Navigation
  89    90    91    92    93  94  95    96    97    98    99  
TM 55-1945-205-10-2 0016 00 3 0016 00 INSTALL MOORING BITTS :,1* Attempting to install mooring bitts on the RRDF in higher sea conditions than Sea State 0 could cause injury or possible death to personnel and/or damage equipment. 127( Mooring bitts can only be installed on female connector assemblies. 1. Raise female guillotine bar. a. Insert crowbar (1) behind spring bar (2) under female guillotine bar (3). b. Rotate crowbar (1) downward to clear spring bar (2) from deck overhangs and allow female guillotine bar (3) to move upward. c. Raise female guillotine bar (3) approximately six in. until it stops. d. Remove crowbar (1). 2. Lift mooring bitt using fork lift and lift chain for installation. 2 1 3







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.