• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
CHANNEL A/B INSTANT ACCESS - TM-55-1945-205-10-2_211
OPERATING PROCEDURES FOR LIGHT TOWERS - TM-55-1945-205-10-2_214

TM-55-1945-205-10-2 Water Purification Barges NSN (1930-01-234-2165) Volume 9-3 Electric Power System Manual
Page Navigation
  168    169    170    171    172  173  174    175    176    177    178  
TM 55-1945-205-10-2 0034 00 1 0034 00 OPERATOR MAINTENANCE ROLL-ON/ROLL-OFF DISCHARGE FACILITY LIGHT TOWERS OPERATION UNDER USUAL CONDITIONS INITIAL SETUP: Tools Life Preserver, Vest (Item 33, WP 0119 00) Gloves, Men’s and Women’s (Leather Palm) (Item 25, WP 0119 00) Goggles, Sun, Wind and Dust (safety) (Item 27, WP 0119 00) Helmet, Safety (Item 29, WP 0119 00) Personnel Required Seaman 88K OPERATING PROCEDURES - OPERATING PROCEDURES FOR LIGHT TOWERS :,1* All personnel must wear personal flotation device, hard hat, safety shoes and gloves during RRDF operations and maintenance. Failure to observe these precautions could result in serious injury or death. Electrical power is present upon cranking engine. Electrical shocks could cause injury or death. 127( The engine in this unit is protected with sensors for high coolant temperature and low oil pressure. Should either of these conditions occur, the engine will automatically stop causing a loss of power to all lamps (except the control panel) and receptacles. Before restarting the unit, check fuel level and engine/radiator thoroughly and correct the problem. The lamps should not be restarted for approximately fifteen (15) minutes. START LIGHT TOWER ENGINE 1. Unplug all external loads from the receptacles (1 and 2).







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.