• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
START MOTOR
TILT MOTOR

TM-55-1945-205-10-2 Water Purification Barges NSN (1930-01-234-2165) Volume 9-3 Electric Power System Manual
Page Navigation
  175    176    177    178    179  180  181    182    183    184    185  
TM 55-1945-205-10-2 0035 00 5 0035 00 &,21 Do not turn the key switch to the start position while the engine is running. Damage to the starter and flywheel will result. Do not exceed 2500 RPM in neutral. Do not exceed 1500 RPM in neutral for extended periods of time. Engine damage could result. 127( Priming is not required when the engine is warm. Do not advance the throttle for starting unless needed to clear a flooded engine. 6. Start engine. a. Turn the key (3) clockwise to the START position and push the key in to prime. b. Crank the engine no longer than 10 seconds or until the engine starts. c. If the engine did not start, release the key momentarily, then try again. d. If the engine does not start, refer to troubleshooting procedures. 7. After the engine starts, perform the following: a. If the engine runs rough, primer may be pushed in several times to make engine run smoothly. &,21 If a steady stream of water is not visible from the water pump indicator, stop the engine immediately. Damage to engine may result. b. Check the water pump indicator. A steady stream of water indicates the water pump is operating. 3







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.