ENGINE WIRING HARNESS REPLACEMENT INSTRUCTIONS (Continued)

ENGINE WIRING HARNESS REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_128

ENGINE WIRING HARNESS REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_130

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
112

TM 5-1940-277-34 ENGINE WIRING HARNESS REPLACEMENT INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS e. Connecting Disconnect by Use hands. cable (13), unscrewing control box retaining ring to console on socket and pulling socket away from control box. f. Receptacle Remove four nuts Use 7/32 in securing and screws. socket and screw- screw (14) driver. This frees receptacle. NOTE Observe cable routing and make notes for use during installation of new cable. g. Wire ties Locate and cut holding wiring with diagonal harness cable cutters. to other cables h. Wiring Pull down until Retain fitting harness fitting (16) for installation cable (15) that nut (12) to new cable. was attached to is clear of box. Slide fitting off cable toward engine. i. Wiring Slide back Use both hands. Harness through hole in Work cable out cable (15) control box in short moves. until cable is removed. 2-99

Privacy Statement
Press Release
Contact