ASSEMBLY (cont) - TM-5-1940-277-34

STARTER MOTOR REPAIR INSTRUCTIONS (Continued) - TM-5-1940-277-34_243

STARTER MOTOR REPAIR INSTRUCTIONS (Continued) - TM-5-1940-277-34_245

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
227

TM 5-1940-277-34 STARTER MOTOR REPAIR INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS 27. Armature (22) Pinion (28), Assemble pinion drive end and drive end shield (1) and shield to the armature (22) armature as follows: a. Pinion (28) a. Pull pinion out and drive drive end end shield shield until (1) lock collar (29) is pressed against spring (34) by solenoid plunger. b. Hold in this position until helix is engaged (step 27d below). b. Lock balls Press fully in (30) and holes. overspeed balls (31) c. Pinion (28) Slide pinion and Take care not to and drive end drive end shield displace balls. shield (1) onto armature shaft (69). d. Pinion (28) a. Engage helix. b. Release pull on pinion (28). c. Screw pinion onto helix. 2-221

Privacy Statement
Press Release
Contact