INSTALLATION - TM-5-1940-277-34

FLYWHEEL AND HOUSING REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_338

FLYWHEEL AND HOUSING REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_340

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
322

TM 5-1940-277-34 FLYWHEEL AND HOUSING REPLACEMENT INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS WARNING Flywheel weighs 87 lbs. Use two men to lift it. Injury to personnel may result. b. Jack flywheel Use 9/16 in soc- off crankshaft ket and 1/2 in by tightening drive ratchet. bolts evenly. e. Ring gear Remove. Use cross tip (16) and 6 screwdriver. screws (17) INSTALLATION 2. Flywheel (14) Ring gear (16) Mount gear on Use cross tip and 6 screws (17) flywheel. screwdriver. 3. Engine assembly a. Crankshaft Clean crankshaft Use honing stone. flange, remove any burrs. b. Flywheel (14) a. Clean mounting Use honing stone. and ring gear face, remove (16) any burrs. b. Fit to crank- Do not hammer. shaft, press into place. 2-321

Privacy Statement
Press Release
Contact