INSTALLATION - TM-5-1940-277-34

TRANSMISSION ASSEMBLY REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_363

TRANSMISSION ASSEMBLY REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_365

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
347

TM 5-1940-277-34 TM 1940-34/3 TRANSMISSION ASSEMBLY REPLACEMENT INSTRUCTIONS LOCATION ITEM ACTION REMARKS INSTALLATION 2. Engine Transmission a. Coat mating Use silicone compartment (1) surface with rubber sealant. sealant. b. Carefully Use 2 persons. lift trans- Transmission must mission into go forward until position at seated against rear of adapter housing. engine. c. Making certain transmission is level, fit transmission spline into damper spline. d. Support trans- mission. 3. Transmission (1) a. 6 mounting Install. Support trans- washers (10) mission at rear. and 6 cap screws (9) b. Brace flat Install. washer (7A), lock washer (7) and cap screw (6) c. Shift control Connect. Transmission cable cotter shift lever (11) pin (4) may be moved to a forward, neutral, or reverse posi- tion as required. Change 4 2-349

Privacy Statement
Press Release
Contact