REMOVAL (cont) - TM-5-1940-277-34

HYDROJET ASSEMBLY REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_372

HYDROJET ASSEMBLY REPLACEMENT INSTRUCTIONS (Continued) - TM-5-1940-277-34_374

TM-5-1940-277-34 Boat Bridge Erection Twin Jet Aluminum Hull Model USCSBMK1 (1940-01-105-5728) Manual
Page Navigation
356

TM 5-1940-277-34 HYDROJET ASSEMBLY REPLACEMENT INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS b. 12 nuts (15), Remove nuts, Two persons 12 washers washers and needed. Use 19 (16), and 12 bolts which mm wrench out- bolts (17) pass through board and 19 mm retaining hull (18); this socket, ratchet intake case frees intake and 18 in exten- case. sion inboard. This also frees drive shaft guard bottom section (2) which must be set aside. It may be necessary to tap bolts through hull; use hammer and drift. c. Sling Attach to hydro- jet unit and to lifting device. Attach sling to intake case only. 5. Hydrojet a. Hydrojet Carefully lift Guide unit out compartment assembly assembly out of compartment of compartment. carefully to Position as prevent damage. required. b. Intake Remove and gasket (19) discard. 2-359

Privacy Statement
Press Release
Contact