TM 5-1940-277-34 TRANSMISSION REPAIR INSTRUCTIONS (Continued) LOCATION ITEM ACTION REMARKS b. External Remove. Use snap ring snap ring (16) pliers.  DO NOT ALLOW DRIVE GEAR TO MOVE FORWARD AFTER SNAP RING REMOVED. c. Drive gear a. Hold ring Use non-metallic and forward gear (18) and hammer.   Assembly clutch hub tap front end will pass through assembly (17) of drive gear ring gear and shaft (19) forward clutch with non- assembly to come metallic out rear end of hammer. ring gear. b. Remove. 7. Drive gear shaft a. 2 sealing Remove and Use small screw- (19) rings (20) discard. driver. b. Snap ring Remove. Use snap ring (21) pliers. c. Forward Remove by Use gear puller. clutch pulling off. hub (22) d. Woodruff Remove. Use fingers or key (23) pliers if stuck. 8. Ring gear (18) a. Bearing (24) Remove from Use non-metallic clutch cylinder hammer. (26) by tapping with non-metallic hammer. 3-109