TM 5-1940-277-34
TRANSMISSION REPAIR INSTRUCTIONS (Continued)
LOCATION
ITEM
ACTION
REMARKS
clutch spring
b. Place assem-
(31). Assembly
bly tool
tool must fit
squarely on
over the collar
top of for-
on forward
ward clutch
clutch cylinder
cylinder and
and set squarely
press down
on cylinder body.
until the
forward clutch
cylinder is
firmly seated
on the clutch
spring snap
ring (32) and
the gear snap
ring groove
is exposed.
c. Ring gear
Install and tap
Use non-metallic
snap ring (25)
to make sure
hammer. Snap
ring seats in
ring is .074
groove.
to .078 inches
(1.89 to 1.99 mm)
thick and has
free diameter of
5-7/8 in + 1/16
in. BE SURE YOU
HAVE RIGHT SNAP
RING.
NOTE
The ring gear subassembly must be turned over at this point. The external splines will now be on
the bottom rather than the top.
3-137