TM 5-1940-277-34
HYDROJET ASSEMBLY REPAIR INSTRUCTIONS-TWO STAGE DRIVE SECTION (Continued)
LOCATION
ITEM
ACTION
REMARKS
DISASSEMBLY
1.
Intake case (1)
a. Hydrojet
Place support
Keeps shaft level
assembly
under rear end
when forward
shaft (2)
of shaft.
supports are
loosened.
b. Washer (3)
a. Remove.
Use 1-1/16 in
and plug (4)
wrench.
b. Catch oil in
Case contains
suitable con-
approximately
tainer.
1/2 pint.
2.
Hydrojet
a. Shaft nut
Hold drive
Use 30 mm socket
assembly
(5) and
flange (7) and
and ratchet. Use
shaft (2)
washer (6)
remove nut and
strap wrench to
washer.
hold flange.
b. Drive
Tap back and
Use hammer.
flange (7)
forward to
loosen cone (8).
c. Drive flange
Remove.
cone (8)
3.
Bearing cap (9)
a. 8 socket head
Remove.
Use 8 mm hex key
screws (10),
wrench (Allen).
8 washers (11)
b. Bearing
Tap lightly and
Use hammer.
cap (9)
remove flange
Bearing assembly
(7) and bearing
contains main
assembly.
thrust washer,
thrust bearing,
front thrust
washer, front
seal sleeve,
spacer.
3-185
