TM 5-1940-322-24
0046 00
BUS BARS AND JUNCTION BOX REPLACEMENT (Contd)
JUNCTION BOX REMOVAL (Contd)
10.
Disconnect wiring harness (1) electrical leads Nos. 47A (2), 14 (3), 34R (4), 34N (5), 4M (6), and 35B (7)
from junction block (8).
11.
Remove conduit nut (62), seal ring (61), collar (60), and electrical leads (2), (3), (4), (5), (6), and (7) from
fitting (59) and junction box (9). Discard seal ring (61) if damaged.
12.
Remove nut (58) and fitting (59) from junction box (9).
13.
Disconnect wiring harness cable G (16) electrical leads Nos. 6 (11), 5 (17), 4 (18), 3 (19), 2 (20), and
1 (21) from junction block (34).
14.
Remove conduit nut (15), seal ring (14), collar (13), and electrical leads (11), (17), (18), (19), (20),
and (21) from right-side fitting (12) and junction box (9). Discard seal ring (14) if damaged.
15.
Remove nut (10) and fitting (12) from junction box (9).
16.
Disconnect wiring harness (1) electrical leads Nos. 46B (36), 39 (37), 40 (38), 41 (39), 43 (40), and
42A (35) from other side of junction block (34).
17.
Remove conduit nut (44), seal ring (43), collar (42), and electrical leads (35), (36), (37), (38), (39),
and (40) from left-side fitting (41) and junction box (9). Discard seal ring (43) if damaged.
18.
Remove nut (50) and fitting (41) from junction box (9).
19.
Disconnect wiring harness cable F (26) electrical leads Nos. 7 (27), 8 (28), 9 (29), 10 (30), 11 (31), and
12 (33) from bottom junction block (52).
20.
Remove conduit nut (25), seal ring (24), collar (23), and electrical leads (27), (28), (29), (30), (31),
and (33) from right-side fitting (22) and junction box (9). Discard seal ring (24) if damaged.
21.
Remove nut (32) and fitting (22) from junction box (9).
22.
Disconnect wiring harness (1) electrical leads Nos. 17 (49), 38A (48), (47), 30K (46), 19A (45), and (57)
from other side of junction block (52).
23.
Remove conduit nut (55), seal ring (54), collar (56), and electrical leads (49), (48), (47), (46), (45),
and (57) from left-side fitting (53) and junction box (9). Discard seal ring (54) if damaged.
24.
Remove nut (51) and fitting (53) from junction box (9).
25.
Remove four locknuts (66), washers (65), screws (67), and junction box (9) from access panel (64),
Discard locknuts (66).
26.
Remove two screws (70), lockwashers (69), and base plate (68) from inside of junction box (9). Discard
lockwashers (69).
27.
If damaged, remove four screws (72), lockwashers (71), and junction blocks (8), (34), and (52) from base
28.
If damaged, remove two screws (75), nuts (73), lockwashers (74), and two isolator blocks (63) from base
0046 00-6