TM 5-1940-322-24
0053 00
NATO SLAVE MAINTENANCE (Contd)
WARNING
Remove all jewelry such as rings, identification tags, bracelets, etc.
If jewelry or disconnected battery ground cable contacts battery
positive post, a direct short can result. Failure to comply may result
in injury or death to personnel and/or damage to equipment.
When removing cables, disconnect the ground cable first. Do not
allow tools to come in contact with vehicle when disconnecting
cable clamps. A direct short can result, causing instant heating of
tools, tool damage, battery damage or battery explosion, and severe
injury to personnel.
REMOVAL
1.
Remove screw (12), washer (11), and battery cable (23) from slave receptacle (4).
2.
Remove locknut (17), two washers (16), electrical leads (15), (14), (13), and (19) battery cable (18),
screw (21), and battery cable (20) from slave receptacle spacer (10). Discard locknut (17).
3.
Remove screw (12), washer (11), slave receptacle spacer (10) and, if necessary, slave receptacle rubber
block (22) from slave receptacle (4).
4.
Remove screw (1) and strap (2) from cap (9).
5.
Remove cap (9) and O-ring (8) from slave receptacle (4).
6.
Remove four locknuts (7), seven washers (6), screws (3), strap (2), and slave receptacle (4) from
bracket (5). Discard locknuts (7).
CLEANING AND INSPECTION
1.
Inspect battery cables, slave receptacle, and slave receptacle spacer for corrosion. If cables, slave
receptacle, or slave receptacle spacer are corroded, clean with parts cleaning brush. For general
cleaning and inspection instructions, refer to WP 0013 00.
2.
Inspect battery cables for damage. Replace if damaged (WP 0054 00).
3.
Inspect O-ring and slave receptacle rubber block for damage. Replace if damaged.
INSTALLATION
1.
Install slave receptacle (4) and strap (2) on bracket (5) with four screws (3) seven washers (6) and new
locknuts (7).
2.
Install cap (9) and O-ring (8) on slave receptacle (4).
3.
Install strap (2) on cap (9) with screw (1).
4.
Install slave receptacle spacer (10) and, if removed, slave receptacle rubber block (22) on slave
receptacle (4) with washer (11) and screw (12).
5.
Install battery cables (20) and (18), and electrical leads (19), (13), (14), and (15) on slave receptacle
spacer (10) with screw (21), two washers (16), and new locknut (17).
6.
Install battery cable (23) on slave receptacle (4) with screw (12) and washer (11).
7.
Connect battery ground cables (WP 0054 00).
8.
Close battery hatch (TM 5-1940-322-10).
0053 00-2
