TM 5-1940-322-24
0083 00
ENGINE WIRING HARNESS REPLACEMENT (Contd)
INSTALLATION
1.
Connect two leads (23) on fuel pump solenoid (22) of fuel injection pump (24).
2.
Connect two leads (20) on engine oil pressure sending unit (21).
3.
Connect engine wiring harness connector (19) to intermediate wiring harness connector (18).
4.
Connect two leads (16) on 10 amp circuit breaker (17).
5.
Connect connector (14) to magnetic pickup connector (15).
6.
Connect two leads (12) on transmission pressure sending unit (13).
7.
Connect two negative (-) leads (8) on ground stud of starter (6).
8.
Connect positive (+) lead (7) to stud on starter solenoid (10).
9.
Connect two leads (9) to starter solenoid (10).
10.
Connect six leads (5) to starter relay (11).
11.
Connect five leads (3) on alternator (4) and install alternator cover and alternator, refer to
12.
Connect two leads (2) on engine coolant temperature sending unit (1).
13.
Install tiedown straps and tape on harness as necessary, to secure engine wiring harness from engine.
14.
Connect battery ground cables (WP 0054 00).
15.
Close battery hatch (TM 5-1940-322-10).
16.
Close engine hatches (TM 5-1940-322-10).
0083 00-4
