TM 5-1940-322-24
0091 00
ENGINE WATER INLET CONNECTION REPLACEMENT (Contd)
NOTE
The engine water inlet connections on both engines are replaced
the same way. This procedure covers the replacement of the engine
water inlet connection on one engine.
REMOVAL
NOTE
Have container ready to catch excess coolant.
1.
Remove hose clamp (11) and hose (12) from engine water inlet connection (10).
2.
Remove hose clamp (2) and hose (1) from elbow (3).
3.
Remove elbow (3) from engine water inlet connection (10).
4.
Remove nut (4) and screw (6) from engine water inlet connection (10) and alternator support brace (5).
5.
Remove two screws (9), engine water inlet connection (10), and seal (8) from engine (7). Discard
seal (8).
INSTALLATION
1.
Install new seal (8) and engine water inlet connection (10) on engine (7) with two screws (9). Tighten
screws (9) to 43 lb-ft (32 Nm).
2.
Install alternator support brace (5) on engine water inlet connection (10) with screw (6) and nut (4).
3.
Apply thin coat of sealing compound on male threads of elbow (3).
4.
Install elbow (3) on engine water inlet connection (10).
5.
Install hose (1) on elbow (3) with hose clamp (2).
6.
Install hose (12) on engine water inlet connection (10) with hose clamp (11).
7.
Fill engine with coolant (WP 0012 00).
8.
Start engine and check for leaks (TM 5-1940-322-10).
9.
Close engine hatches (TM 5-1940-322-10).
0091 00-2
