TM 5-1940-322-24
0104 00
AIR CLEANER MAINTENANCE (Contd)
NOTE
The air cleaners on both engines are replaced the same way. This
procedure covers the replacement of one air cleaner.
REMOVAL
Remove clamp (2) and air cleaner (1) from air inlet (3).
CLEANING AND INSPECTION
1.
For general cleaning and inspection instructions, refer to WP 0013 00.
WARNING
Compressed air source must not exceed 30 psi (207 kPa). Wear
eyeshields when cleaning with compressed air. Failure to wear
eyeshields may result in injury to personnel.
CAUTION
Do not use solvent to clean air cleaner. Failure to comply may
result in damage to equipment.
2.
Clean air cleaner (1) with compressed air.
3.
Inspect air cleaner for dirt. Replace if dirty after cleaning.
INSTALLATION
1.
Install air cleaner (1) on air inlet (3) with clamp (2). Tighten clamp (2) to 71 lb-in (8 Nm).
2.
Close engine hatches (TM 5-1940-322-10).
0104 00-2
