TM 5-1940-322-24
0166 00
TRANSMISSION REPAIR (Contd)
REAR HOUSING AND OUTPUT SHAFT DISASSEMBLY
1.
Using bearing puller, remove tapered roller bearing (6) from output shaft (7).
2.
Remove two screws (9), washers (10), and oil pan (8) from rear housing (11).
3.
Remove snapring (13) from output shaft (7).
4.
Install oil injector adapter tool TD-300350 on end of output shaft flange (14).
WARNING
Gear may leave shaft with force when pressure is applied to
adapter tool; restrain gear to prevent possible damage to gear and
housing or injury to personal.
5.
Using SKF oil injector, apply high pressure oil to adapter tool TD-300350 to remove gear (12) from
tapered end of output shaft (7) and rear housing (11).
6.
Turn over rear housing (11) and support on hydraulic press with output flange (14) down. Press
output shaft (7) out of tapered roller bearing (17).
7.
Remove tapered roller bearing outer races (15), (16), and (18) from rear housing (11).
8.
Remove output shaft oil seal (19) from rear housing (11). Discard oil seal (19).
9
8
BEARING PULLER
10
6
11
13
12
7
7
HYDRAULIC PRESS
12
17
16
7
18
15
11
11
19
7
14
14
0166 00-7
