TM 5-5420-202-20-2
TM 5-5420-202-34
FUEL SHUTOFF CABLE ASSEMBLY REPLACEMENT (Sheet 7 of 13)
17.
Wrap and securely tie 8 inches of a 10 foot length of wire (AG) around rear end of
cable assembly (L).
NOTE
Wire (AG) will be used during installation
to thread cable assembly through guide
tube (AH) and bulkhead connector (U).
18.
Using two persons, remove cable assembly (L) by slowly pulling cable assembly (L)
into engine compartment allowing wire (AG) to thread through guide tube (AH) and
bulkhead connector (U).
19.
Untie wire (AG) from rear of cable assembly (L) and remove cable assembly (L) from
operators compartment. Leave wire (AG) in hull for cable assembly installation.
Go on to Sheet 8
74348
- - 70
Change 5
