TM 5-5420-202-20-3
HEADLIGHT ADJUSTMENT (Sheet 2 of 2)
Turn on service drive headlights, low beam
9.
10.
Center of maximum light intensity should be
centered on line (D).
11. If not, using 9/16 inch wrench, loosen three screws
(G) and adjust by tilting headlight (H) to desired
angle.
NOTE
Adjust both left and right
headlights in same manner.
12.
Using 9/16 inch wrench, tighten three
screws (G).
Check to see if light intensity for left headlight is
13.
centered on intersection of lines (D and E).
14.
If not, using 7/16 inch wrench, loosen three screws
(J) at base of headlight.
15.
Turn headlight (H) until in proper position.
16. Using 7/16 inch wrench, tighten three screws (J)
when adjusted.
17.
Repeat steps 13 through 16 for right headlight
using lines (D and F).
18.
Turn off lights (TM 5-5420-202-10).
TA249159
End of Task
10-218
