TM 5-5420-202-34
ROADWHEEL ARM REPAIR (NUMBER 1 LEFT AND RIGHT) (Sheet 4.1 of 7)
ASSEMBLY:
Position shock absorber bearing (A) on arm (B).
1.
Install replacer over bearing (A) and arm (B). Turn
replacer nut until bearing (A) is centered in arm (B).
Remove replacer.
2.
Stake bearing (A) to arm (B) at three
equally spaced locations on each side
of bearing (A).
NOTE
If replacing bearing for mechanical
track adjusting link, perform steps 2.1
and 2.2. If replacing bearing for grease
actuated track adjusting link, perform
steps 2.3 and 2.4.
2.1.
Position bearing (C) on arm (B). Install
bearing driver over bearing (C). Turn nut of
bearing driver until bearing (C) is centered
in arm (B). Remove bearing driver.
2.2.
Stake bearing (C) to arm (B) at three
equally spaced locations on each side of
bearing (C).
2.3.
Position bearing (D) on arm (B).
secure bearing tool assembly to bearing
(D) with screw and nut. Install puller
to bearing tool assembly and drive
bearing (D) in arm until centered.
Remove bearing tool assembly and puller.
2.4.
Stake bearing (D) to arm (B) at three
equally spaced locations on each side
of bearing (D).
Go on to Sheet 5
Change 2 9 - 5
