TM 5-5420-209-12
4-90. Hydraulic Pumps.
This task covers:
a. Service
b. Replace
INITIAL SETUP
General Mechanics Automotive Tool Kit
(Item 1, Appendix B)
Materials/Parts
Oil, Lubricating OE/HDO (Item 8, Appendix E)
Tape, Antiseize (Item 19, Appendix E)
Equipment Condition:
Bay unfolded (para. 2-14).
NOTE
The following procedures are the same for both hydraulic pumps.
a. Service. (figure 4-117)
(1) Open pump access cover (1).
(2) Remove vent and fill cap (2) and check level of hydraulic fluid. Fluid level should be approximately 2 in. (5.18
cm) below top outside surface of pump (3).
(3) Install vent and fill cap (3).
(4) Close pump access cover (1).
Tool
4-294