ARMY TM 5-5420-212-10-1
MARINE CORPS TM 08676A-10/1-1
c.
Pallet Load ED
(1)
Place four launching nose heavy sections on pallet as shown.
(a)
Front end of nose sections are flush with front edge of pallet.
(b)
Sides of outer nose sections are flush with sides of pallet.
ED
(2)
Place one launching nose heavy section on top of nose section on right side of pallet.
(3)
Place one landing roller pedestal on rear of pallet and against rear of nose sections. Place landing roller
upside down in landing roller pedestal.
ED
(4) Place two baseplates on top of landing roller pedestal, then place two longitudinal girders on top of the two
center nose sections and baseplates. Ensure that the ends of the longitudinal girders are flush with the front
of the nose sections.
3-96
