ARMY TM 5-5420-212-10-1 MARINE CORPS TM 08676A-10/1-1 COMMON NAME OFFICIAL NOMENCLATURE Push Bar Long (PB) Push Bar, Long, Launching, Bridge Push Bar Short (PB) Push Bar, Short, Launching, Bridge Ratchet Wrench 3/4 inch Wrench, Ratchet, Reversible 3/4 inch Retainer Clip Clip, Panel Pin Rocking Roller Roller Assembly, Rocking, Bridge Roller Beam (RB) Roller Beam, Bridge Rubber Buffer Pallet, Rear Buffer Assembly Short Ramp Ramp Unit, Bridge Short Reinforcing Link Link, Reinforcing, Short Strap, 5,000 lb Strap 5,000 lb Strap, 10,000 lb Strap Webbing 10,000 lb Sway Brace Brace, Sway Tie-Down Lug Lug, Tie-Down Top Panel (TP) Panel, Top, Bridge Trailer Mounting Equipment Trailer Mounting Equipment Truck Mounting Equipment Truck Mounting Equipment 1-5. LIST OF ABBREVIATIONS A = Junction panel in far bank end of bridge A = Edge of gap, far bank, marked with A peg A’ = Edge of gap, near bank, marked with A’ peg AA = Anchor assembly, component in link reinforcement set AA(L) = Anchor assembly, long. AA(S) = Anchor assembly short AF = Antiflutter tackle approx.  = approximately AR = Angle of repose which is marked on site with A (far bank) and A’ (near bank) pegs atten. = attention B = Top panel in the far bank end of bridge, on the bank side of the junction panel BP = Bottom panel.  This will also be found with number following BP: Examples: BP1, BP2, BP = Building pedestal BSB = Bankseat beam C = Top panel in the far bank end of bridge, on the bank side of the bankseat beam C = Distance of water below line joining FRB and F at distance W from FRB (negative) CL = Centerline cm = centimeter CRB = Capsill roller beam d1/d2 = Gaps between level string and top panels when checking girder toe in 1-4