ARMY TM 5-5420-212-10-1
MARINE CORPS TM 08676A-10/1-1
(13) Bracing Pin
Used to connect sway braces to sway brace brackets and to connect the push bar to the push bar adapter and
push bar cross girder. The bracing pin is also used on the panel erection aid.
NOTE
The pin used In the fork end anchors of the IRS anchor assemblies is the only pin that can be
hammered on. These pins may be hammered into place using the plastic faced hammer that is
provided in the set.
(14) Retainer Clip
Retainer clips are inserted through the hole at the end of all pins for safety. It is good practice to clip all pins, even
though it is not essential when connecting bankseat beam to end taper panel, and bottom panel to top panel.
b.
Erection and Launch Components. The erection and launch components are illustrated and the function of
each is explained.
(1)
Baseplate, Single Story
The baseplate is used under the fixed supports as a base for the roller beam, and with the jack supports as a base
for the hydraulic jack. The baseplate can be placed on timber 3 in x 8 in x 36 in (75 mm x 200 mm x 900 mm), or on deck
unit packing. The sloping edge always faces the gap.
BRACING PIN
RETAINER CLIP
SINGLE STORY
BASEPLATE
1-27