TM 5-5420-226-20-2
TM 5-5420-202-34
FUEL TANK (RIGHT) REPLACEMENT (Sheet 6 of 15)
21.
Using 1/2 inch socket or 1/2 inch
wrench, remove four screws and washers
(AJ) securing mount (AK) and bracket (AL)
to hull.
CAUTION
Fuel tank is fabricated of aluminum
and is therefore subject to damage
from sharp objects. Use utmost
care during handling. Do not force
tank with poles or bars as damage
may result.
During disassembly,
s e v e r a l tank openings may be
exposed. Close these openings
with masking tape to prevent entry
of foreign matter.
22.
Using three persons, pivot fuel tank toward center
of hull while slowly moving fuel tank rearward
until rear end of fuel tank clears curve in hull.
NOTE
Flat lower front section of fuel
tank must be held horizontal while
under crew compartment floor to
avoid binding.
Go on to Sheet 7
7-378
Change 6
4-14