TMTM 420-226-20-3
5-5 5-5420-202-20-3
STARTER FEED WIRING HARNESS REPLACEMENT (Sheet 2 of 5)
NOTE
Strap type clamps should be left in
place by removing only one screw.
If replacement of strap is required,
remove both screws.
NOTE
Some vehicles have a cable tie
instead of strap (E). If your vehicle
has a cable tie, remove it and go on
to step 3.
2.
Using 7/16 inch wrench, remove screw
(B), lockwasher (C), and flat washer
(D) from strap (E).
3.
From engine compartment, using 7/16
inch wrench, remove screws (F), lock-
washers (G), and flat washers (H) from
three straps (J).
Go on to Sheet 3
CChange6 10-296.3
hange 7 10-296.3