TM 5-5420-226-20-3
FINAL DRIVE VENTING SYSTEM REPLACEMENT (Sheet 7 of 10)
6.
Using fingers, connect tube assembly (C) to tee(F).
Install clamp (G) onto tube assembly (H) and position tube assembly (H) onto hull.
7.
Using fingers, connect tube assembly (H) to tee (F).
8.
9.
Using adjustable wrench to hold tee (F) and using torque wrench with 11/16 inch crowfoot,
tighten tube assembly (C and H) nuts to 75-85 lb-in. (8.4-9.5 Nm).
10.
Using 7/16 inch wrench, install and tighten screw (J) and new lockwasher (K) securing clamp (G) to
hull.
Go on to Sheet 8
Change 3
12-30
