TM 5-5420-226-20-3
STEERING CONTROL ROD REPLACEMENT (Sheet 3 of 3)
INSTALLATION:
1.
Using 9/16 inch wrench, install jamnuts (A) and rod ends (B) on rod (C).
2.
Using 9/16 inch wrench and steel tape, obtain measurement between centers of holes
in rod ends (B).
3.
Using torque wrench and crowfoot adapter, tighten nuts (A) against rod ends (B) to
a minimum torque of 192 lb-in. (22 N m).
4.
Position rod end (B) in steering control handle (D).
Using 9/16 inch wrench, install bolt (E) in steering control handle (D).
5.
Position other rod end (B) in link (F).
6.
7.
Using 9/16 inch wrench, install bolt
(G) in link (F).
8.
Test operation of steering control rod (C) linkage (TM 5-5420-226-10).
End of Task
TA169368
15-8