TM 5-5420-226-20-3
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 12 of 22)
58.
Using 9/16 inch wrench, turn steering rod
end (AB) clockwise until control rod (AD)
is just past witness hole in steering rod
end (AB).
59.
Using. 9/16 inch wrench to hold steering
rod end (AB), use 9/16 inch wrench to
tighten jamnut (AC).
60.
Using 9/16 inch wrench, remove screw
(AG).
61.
Position steering rod end (AB) in clevis
(AE) and using 9/16 inch wrench, install
screw (AA).
62.
Using torque wrench and crowfoot, tight-
en screw (AA) to 16 lb-ft (22 Nm).
63.
Using 9/16 inch wrench to hold steering
rod end (AF), use 9/16 inch wrench to
loosen jamnut (AH).
64. Using 9/16 inch wrench, turn steering rod
end (AF) counterclockwise until screw
(AG) will drop freely through clevis (AJ)
and steering rod end (AF).
TA169402
Go on to Sheet 13
15-42