TM 5-5420-227-24
NIGHT VIEWER LATCH REPAIR (Sheet 9 of 10)
23. If operating push rod parts were not disassembled, proceed to step 29.
Start new nut (S) onto rod (T) with locking
24.
collar first. Run it on to approximately
1/4 inch from end of threads. Use 1/2 inch
wrench if locking collar is tight. Use vise
if necessary.
Place sleeve (U) on rod (T).
25.
26. Insert pivot (V) in plunger (W). Using hammer, drive in two pins (X) through pivot (V).
N OT E
Posit ion pins (X ) t hrough pivot (V ) so t ha t t he y e a c h st ic k
t hrough pivot e qua lly on bot h side s.
27.
Pivot (V) has flat faces on two surfaces. Rotate pivot so smaller flat face is
facing sleeve (U). Slide rod (T) through pivot (V).
28.
Using socket, install nut (Y) onto rod (T) while holding nut (S) with 1/2 inch
wrench.
Go on to Sheet 10
3-32.14 Change 1