TM 5-5420-227-24
TONGUE CYLINDER HOSE ASSEMBLIES REPLACEMENT (CH, CK1, AND CK2) (Sheet 3 of 4)
INSTALLATION:
NOTE
Remove all caps and plugs as necessary during installation.
Before installation, use pipe tape on all male threads. Start
tape on second thread so tape will not enter hydraulic
system.
1.
Holding adapter (A) with 1-1/8 inch wrench,
use 1-1/4 inch wrench to install hose
assembly "CH" (B) on adapter (A).
2.
Using 12 inch adjustable wrench, install
elbow (C).
3.
Holding elbow (C) with 12 inch adjustable
wrench, use 1-1/4 inch wrench to install
hose assembly "CH" (B) and collar (D) to
elbow (C).
4.
Holding elbow (E) with 15 inch adjustable wrench, use 1-1/4 inch wrench to install hose
assembly "CK2" (F) to elbow (E).
5.
Using 12 inch adjustable wrench, install elbow (G) in tee (H).
6.
Holding elbow (G) with 12 inch adjustable wrench, use 15 inch adjustable wrench to install
elbow (J) into elbow (G).
7.
Holding elbow (J) with 15 inch adjustable wrench, use 1-1/4 inch wrench to install hose
assembly "CK1" (K) on elbow (J).
Position nuts (L), flat washers (M) and packings (N) on elbows (P).
8.
Manually install two elbow assemblies (P).
9.
10.
11.
TA170357
Go on to Sheet 4
3-131