TM 5-5420-228-24
OVERHEAD CYLINDER RETURN HOSE ASSEMBLY (F) REPLACEMENT (Sheet 2 of 2 )
INSTALLATION:
NOTE
Before installation, use pipe tape on all
male threads. Start tape on second thread
so tape will not enter hydraulic system.
1.
Using adjustable wrench to hold elbow (A),
use 1-1/4 inch wrench to install hose
assembly "F" (B).
2.
Manually place elbow nut (C), flat washer
(D) and new preformed packing (E) on
elbow (F).
3.
M a n u a l l y install elbow (F) on vehicle.
Aline elbow (F) as shown.
4.
Using adjustable wrench to hold elbow (F),
use 1-1/4 inch wrench to tighten elbow nut
(c).
5.
Using adjustable wrench to hold elbow (F),
use 1-1/4 inch wrench to install hose
assembly "F" (B).
6.
7.
Check for hydraulic leaks and correct as
necessary.
8.
Service hydraulic reservoir as needed (LO 5-
5420-202-12).
TA251563
End of Task
3-164