TM 5-5420-228-24
DRIVER'S HATCH NIGHT VIEWER LATCH REPAIR (Sheet 6 of 10)
5.
Insert shaft (F) with offset threaded portion in
down position (nearest support (A) and tooling
hole facing you).
6.
Line up loop of spring (D) with holes of sleeve
(E) and shaft (F).
7.
Place washer (G) on pin (H) and insert pin from
the back side.
8.
Insert new cotter pin (J) through hole in pin
(H).
9.
Using screwdriver and pliers, bend legs of cotter pin (J).
NOTE
If handle was not disassembled, go to step 13.
10.
Place lever (K) on bench and, using hammer,
drive pin (L) partly through lever.
11.
Place handle (M) on bench and position spring
(N) in recess of handle and lever (K).
12.
Using hammer, drive pin (L) through lever (K)
and handle (M).
Go on to Sheet 7
TA251772
3-275