TM-5-5420-279-10
3.2.1.19
Step onto the tail lift and re-insert the shootbolt to secure it in the extended position,
locking it in place with the pin clip. If necessary, adjust the position of the tail lift platform
to move the far bank support to align the holes and facilitate installation of the shootbolt.
3.2.1.20
Release the SWING DOWN switch when the far bank support is fully extended.
3.2.1.21
Insert the upper shootbolt and lock in place with a retaining clip. If necessary, adjust the
position of the tail lift platform to move the far bank support to align the holes and facilitate
installation of the shootbolt.
3.2.1.22
On the tail lift pendant, operate the SWING DOWN switch to lower the tail lift away from
the far bank support.
3.2.1.23
Put the far bank support bearing pads in position on the tail lift platform.
3.2.1.24
On the tail lift pendant, operate the LIFT UP switch to raise the tail lift platform.
Tail Lift Pendant
3.2.1.25
Release the LIFT UP switch when the attachment holes in the bearing pads and the far
bank support are aligned.
3.2.1.26
Connect the bearing pads to the far bank support by retracting the spring-loaded pin,
inserting the ball joint and re-inserting the pin. Make sure the spring-loaded pin is fully
engaged.
3-18
