TM-5-5420-279-10
7.20.1.10
To swing down the tail lift operate SV30b, screw in both the SWING cylinder knurled
screws (one on each cylinder) (refer to Figure 7. 6 for location) slowly until
movement occurs. To stop the swing down, screw out the knurled screws on the
valves.
NOTE
The slower the action of screwing in or out the knurled screws the more control is
exercised over the movement of the tail lift.
7.20.1.11
To lower the platform operate SV30b, screw in both the LIFT cylinder (refer to
knurled screws out when the platform is at the desired level.
7.20.1.12
To level the platform operate SV30b or SV30a depending on which way the platform
is required to travel, screw in both the TILT cylinder (refer to Figure 7. 6 for location)
knurled screws slowly until movement occurs. Screw the knurled screws out when
the platform is at the desired position.
7.20.1.13
To reverse the operation of the tail lift, push in the head of SV30a or SV30b
depending on the direction required and clip. Repeat procedures above for desired
action.
7-29
