TM 5-5420-280-23&P
0065 00
WINCH ELECTRICAL HARNESS, CONTROL CABLE, AND POWER SUPPLY CABLE REPLACEMENT (Contd)
POWER SUPPLY CABLE REMOVAL
NOTE
Tag all leads for installation.
1. Disconnect power supply cable connector (3) from electronic box receptacle (6) on electronic box (1).
2. Remove tie-down straps (4) and power supply cable (5) from winch assembly (2) and A-frame (7)
back to electrical box (8) on pallet frame (9).
3. Open cover on electrical box (8) refer to WP 0049 00 and disconnect two electrical leads from power
supply. Refer to Electrical System Schematic WP 0122 00.
4. Loosen nut on fitting and remove power supply cable (5) from fitting, grommet, and side electrical
box (8). Refer to WP 0049 00.
POWER SUPPLY CABLE INSTALLATION
1. Install power supply cable (5) through nut, grommet, and fitting into electrical box (8). Tighten nut
after electrical leads are connected. Refer to WP 0049 00.
NOTE
Connect all electrical leads as tagged at removal.
2. Connect two electrical leads to power supply. Refer to Electrical System Schematic WP 0122 00 and
close cover on electrical box (8). Refer to WP 0049 00.
3. Route power supply cable (5) up to winch electronic box (1) along A-frame (7) and secure with
tie-down straps (4) as necessary.
4. Connect power supply cable connector (3) to electronic box receptacle (6) on electronic box (1).
0065 00-8
